Leak Gopher Z-Wave Leak Detector

Z-Wave Inclusion How to Add the Leak Gopher Leak Detector to your Z-Wave Controller - Plug the wall cube power adapter (included) into the receptacle on the bottom of the Leak Gopher Z-Wave Valve Control marked '5 VDC'. Plug the wall cube into a 110 VAC outlet. This provides power to the Leak Gopher Z-Wave Leak Detector. - Configure the Z-Wave Controller to Include/Add a device. - When the Z-Wave Controller is ready to include/add a device, it will display a message like 'waiting to add device'. Press and release the Z-Wave button on the front of the LGZWLD. - The Z-Wave Controller will acknowledge that the LGZWLD has been added to the Z-Wave network. - Your Leak Gopher Z-Wave Leak Detector is ready to use. Inclusion without Security If your home automation hub is does not support the Z-Wave Security Command class, tap the Z-Wave button two times. Tapping the button twice will send a simpler message to the hub which will not include the security command classes. Inclusion Legacy Mode If your home automation hub does not support the Z-Wave Notification Command Class, the LGZWLD can substitute the simpler Binary Switch command class. To enable Legacy Mode, tap the Z-Wave button three times during inclusion. Virtually all hubs support the Binary Switch command class.