How to Add the Leak Gopher Z-Wave Valve Control to your Z-Wave Controller - Plug the wall cube power adapter (included) into the receptacle on the bottom of the Leak Gopher Z-Wave Valve Control marked '3.6 VDC'. Plug the wall cube into a 110 VAC outlet. This provides power to the Leak Gopher Z-Wave Valve Control. - Configure the Z-Wave Controller to Add a device. - When the Z-Wave Controller is ready to add a device, it will display a message like 'waiting to add device. Press Add button on the device' - The Add/Remove button is located on the side of the Leak Gopher Z-Wave Valve Control. Press the Add/Remove button. - The Z-Wave Controller will acknowledge that the Leak Gopher Z-Wave Valve Control had been added to the Z-Wave network. - Your Leak Gopher Z-Wave Valve Control is ready to use.

Frequently asked questions

Does the Water Valve Control work with Home Assistant?

Yes — the Water Valve Control is supported by Z-Wave JS, the modern Z-Wave stack used by Home Assistant. Pair it through the Z-Wave JS UI or the Home Assistant Z-Wave integration. A Z-Wave controller is required.

What protocol does the Water Valve Control use?

The Water Valve Control communicates over Z-Wave.

Data: zwave

← Back to results